PAS 9883/GEN, 8 Channel, Synchronized
Sine/Pulse Generator Card
Links to printable product info:
The PAS 9883/GEN is a VME based, eight channel function generator
card. Each channel contains a Direct Digital Synthesis (DDS) chip
that can be programmed to generate sine wave output signals. This
DDS device is a Numerically Controlled Oscillator (NCO), employing
a phase accumulator, a sine look-up table and a 10 bit D/A converter.
The input clock frequency to the DDS chips is 2 MHz. This input
frequency combined with the chips thirty-two bit phase accumulator
provides a frequency resolution of 0.000465 Hz. The maximum useable
output frequency is approximately 30 KHz.
A Multiplying Digital-to-Analog
Converter (MDAC) is provided on each channel, following the DDS.
This allows the card’s output
voltage to be set from 0 to +/-10 volts in 5 mV steps. In addition
to the sine wave output a TTL output and open drain FET output
are provided on each channel.
This card can be used in VME systems
with A16, A24, or A32 addressing, and data bus widths of 16 and
32 bits are supported. DIP switches
are used to configure the width of the address bus. VME instruction
types determine the width of the data bus. The output signals
are connected to a pair of DB37 female connectors mounted through
the
front panel. A board identifier PROM, control register and DDS
frequency and phase control registers are provided as well.
Card Features: PAS 9883/GEN
-
8 channel Direct
Digital Synthesis (DDS) Waveform Generator
-
Each channel provides
sine wave, TTL square wave and open drain FET outputs
-
Multiplying Digital-to-Analog
Converter (MDAC) per channel provides output voltage of 0 to
+/-10 volts
in 5 mV steps
-
Output frequency
is controlled by a 32 bit frequency register; each channel
provides an independent frequency register
-
Output
frequency is set by the following equation: F(out) = F register
value x 2 MHz divided by 2^32
-
Each channel’s
output phase is controlled by two independent 12 bit phase
offset registers
-
All channels are
clocked by a common 2 MHz crystal controlled oscillator
-
All channels can
be synchronized, to allow known phase offset from channel to
channel
-
Sine wave output
amplifiers provide a low pass filter with a 3dB corner frequency
of 30 KHz
-
VME 6U
form factor, 233mm x 160mm card size
-
VME access:
A32, A24, A16; D16 slave – No VME interrupts
-
Board provides ID
code (VMEIDPAS9883GENA), control and status register and three
status LEDs
-
Operating temperature
range 0 to 60 degrees Celsius
Contact us for current pricing:
|