PAS 9764/DIO : 32 Channel VME Change
of State Card with Time Stamping
Links to printable product info:
The PAS 9764/DI is a VME based, 32 channel, digital input
card with Change of State (COS) detection and time stamping. Input
signals are monitored and when a change of state is detected, the
card will store the state of the input signals and the time of the
change as determined by an internal clock in an on board FIFO memory.
The FIFO can be read from the VME bus to retrieve the input state
and time data. VME interrupts will be generated in the event of
transitions on selected input signals.
This card can be used in VME systems with A16, A24, or A32 addressing,
and data bus widths of 16 and 32 bits are supported. Jumper plugs
are used to configure the width of the address bus. VME instruction
types determine the width of the data bus. The input signals are
connected to a pair of 50 position shrouded headers mounted through
the front panel. A board identifier PROM, interrupt vector
register, and control register are provided in addition to
the 32 bit counter and 64K word by 32 bit FIFO.
Key Features
-
32 differential input bits with characteristics specified
by EIA-422B
-
Input signals on two 50 position shrouded headers
at the front panel.
-
Detects change of state on low to high
transition or high to low transition.
-
Time stamps every transition
and stores data and time stamp in a FIFO memory. The FIFO
is 32 bits wide by 64K words deep.
-
VME interrupts are generated if the line that changed was
enabled to generate interrupts.
-
VME bus reads 32 bits of data
followed by 32 bits of time from the FIFO.
-
Counters are enabled
with a control word write.
-
Status register contains the following
bits; Pass, Fail, Monitor Enable, Interrupt Enable,
Interrupt Level, Counter Rate, FIFO Empty, FIFO Half Full,
FIFO Full.
Contact us for current pricing:
|